Rob Stimpson

Program time is longer than the upper limit "9999.99 min".   Do not set the total time longer than 9999.99 min. The analysis can be performed even after this message is displayed, however, the...

Program time is longer than the upper limit "9999.99 min". Do not set the total time longer than 9999.99 min. The analysis can be performed even after this message is displayed, however, the progr...

Clean up program cannot be started because oven temperature is not ready.   Set the initial temperature of the column oven at higher values than room temperature by more than 2℃. （Example, Set the ...

Exceeded the set threshold of CRG coolant consumption (Operating Time). Replace the coolant and then reset the counter.   ＜GC instrument monitor setting＞   Press HOME button > [Function] > [Diagno...

Usage time exceeds the set value.   Risk of current leakage, heat, smoke, and ignition increases. Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/serv...

Exceeded the set threshold of inlet septum counter.   Replace the septum and then reset the counter.   Counter reset:   ＜GC instrument monitor setting＞   Press HOME button > [Function] > [Diag...

Exceeded the set threshold.   Replace the insert and then reset the counter.   Counter reset:   ＜GC instrument monitor setting＞   Press HOME button > [Function] > [Diagnosis] > [Analysis counte...

FID or FPD ignition failed. Check the following items.   Detector gas flow rate:   Press (HOME) - [Detector] button on GC instrument monitor (HOME) and display the folloeing screen. Make sure that...

Detector ignition sequence was re-attempted, because the ignition failed initially.   Check the following items.   ・Check for gas leaks. ・Verify the gas flows. 　  ・Diagnose ignition pulse and...

Risk of current leakage, heat, smoke, and ignition increases because usage time exceeds the set value.   Turn off the main power of the instrument, stop gas supply, and contact your Shimadz...