Gas Chromatography
- (GC) RS232 Connection Troubleshooting with GC-2010
- (GC) Starting the GC after the Hydrogen Generator has turned off
- CARm AFC PCB error [Error Code:11 12 53 54]
- DET#1 2 3 4 PCB error [Error Code:7 8 9 10]
- AOCn syringe counter error [Error Code:88 89]
- CARx insert counter error [Error Code:84 85 86 87]
- CARx septum counter error [Error Code:80 81 82 83]
- AUX3-AUX5 relay error [Error Code:1047]
- INJ1-DET2 relay error [Error Code:1046]
- COL relay error [Error Code:1045]
- Power controller board com. failed [Error Code:4045]
- DET#1 2 3 4 FPD cooling fan error [Error Code:4121 4122 4123 4124]
- SCD detector abs. press is high [Error Code:9079]
- xxx sensor error [Error Code:1026 1027 1028 1029 1030 1031 1032 1033 1056]
- xxx sensor is down [Error Code:1018 1019 1020 1021 1022 1023 1024 1025 1055]
- xxx sensor is short circuit [Error Code:1010 1011 1012 1013 1014 1015 1016 1017 1054]
- SCD furnace abs. press was exceeded upper limit [Error Code:6112]
- SCD furnace abs. press fell below lower limit [Error Code:6111]
- SCD furnace temperature set point not reached [Error Code:6106]
- SCD furnace temperature controller error [Error Code:6105]
- SCD furnace temperature exceeds the limit [Error Code:6104]
- SCD furnace temperature sensor error [Error Code:6103]
- SCD furnace temperature sensor is down [Error Code:6101]
- Untitled
- SCD hydrogen was overpressure[Error Code:6164]
- APCy set point not reached[Error Code:2026 2027 2028 2029 2030 2031 2032 2033 2034 2035 2036 2037 2038 2039 2040 2041 2042 2043]
- DetAPCn air set point not reached[Error Code:2016 2019 2022 2025]
- DetAPCn hydrogen set point not reached[Error Code:2015 2018 2021 2024]
- DetAPCn makeup set point not reached[Error Code:2014 2017 2020 2023]
- Oven door is open[Error Code:1061]